Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Air flow sensor slow to drop 200 1979

posted by  richink on  Sun Oct 27 08:58 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Dec 22 04:40 CST 2010
[RELATED]

Hello,

Sounds like real fun!!! If I was closer I'd come over to help you myself. The airflow plate should take a few seconds to drop from full extension. Undo the blot, it's a 10mm if memory serves me correct, spray a rag and clean it all up. Just make sure that there is no interference when you reinstall the disc, it's not too hard to line up. As far as the rest of it is all concerned, you may want to replace the injector seals as you have it all apart already, but be very liberal with carb cleaner. Once you do get it all back together and attempt the restart, it will be a little temperamental, but it will kick over and send a large cloud out the back. Just when you are reassembling everything make sure that the wiring harness that clips on to the mass flow plate makes good contact. Other than that....

Happy Bricking!!!

Richard
87 245 338,000km and counting
84 244 Turbo Intercooler (real man's toy)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Air flow sensor slow to drop [200][1979]
posted by  brucebcd  on Sun Oct 27 07:33 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.