Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2017

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

PS..make your own seal installer!

posted by  someone claiming to be JohnB on  Thu Nov 7 04:55 CST 2002 [RELATED]

Take a piece of PVC pipe or a fitting and grind it to fit using a circular sander or drum sander depending on whether you're fitting the inside or outside diameter of the seal.

Theoretically you could even put a cap on the end and drill a hole to fit the balancer bolt and use the balancer bolt to press in the seal ala the volvo too. But most people just tap it in. Works fine.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New SPX/Kent-Moore will only sell Volvo tools to Volvo dealers... any similar experiences?
posted by  weezy  on Thu Nov 7 03:56 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.