Hello guys,

I wrote earlier about this lamp and found a good replacement. The repeat of this message is as follows (as stated these lamps were what I used to replace the A/C lights as well as the dash lights - In the case of the A/C just disassemble the old leads and rewire with these lamps):
_______________________________________
Hello fellow board members,

I have found a replacement bulb. It comes in a 2 pack and is made by GC Electronics - Part # ML2182. T-1 3/4 Wire Terminal (14volt, 0.08Amps)-Indicator Lamp.

To repair: you must remove/crush the old bulb from the holder and then fit these replacement lights into the empty socket (luckily the wire leads are thin) and solder the leads into place. Voila, you have the original socket with a new bulb!!

GREG SHUTT, if you are out there, these lights will work on the A/C light panel as well. You just have to unwind the old bulb and then rewind the new leads of the replacement bulb onto the base (these bulbs are a little dimmer than the originals).

Good luck and hopefully this puts an end to getting screwed over. Just my 2 cents.


Tim.