Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Drive shaft alignment 700

posted by  Matt L on  Sat Jan 4 09:16 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 23 08:46 CST 2010
[RELATED]

Great tip. The problem I once had (because of carelessness) is that I removed the center universal joint, and managed to re-install it 180 degrees out of phase. This meant that even if I lined up the splines correctly the 2 halves of the driveshaft were no longer balanced. Of course I will never do THAT again! Always mark the driveshaft before removing universal joints so that you get them back in the same way.

--
Matt L. -- Cary, NC -- '91 740 wagon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Drive shaft alignment [700]
posted by  john sargent subscriber  on Fri Jan 3 15:46 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.