Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear upper torque rod differences? 200

posted by  Bob Wennerstrom on  Sun Feb 2 11:12 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 15 12:01 CST 2011
[RELATED]

You say you "melted" out the old bushings. Did you drive the outer steel bushing sleves out after you melted out the rubber? I may be incorrect here but I think the rubber bushings have a steel sleeve around them and the poly don't. That's why I was told you don't need a press to put in poly bushings but you do to put in the rubber ones. If the sleeve is still in there, the hole will be too small.

Bob
'82 245 turbowagon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear upper torque rod differences? [200]
posted by  jbowser  on Sun Feb 2 05:41 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.