Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

It wouldn't start! 700

posted by  UncommonDenominator on  Tue Mar 4 02:41 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Right after i installed my new fuel pump in my car, i noticed that the thing would studder like mad. Especially at low speeds. I checked everything i could to think of why it would do that. In the end, i remembered removing the injectors to see if i was getting any pressure. I also took off each of the electrical clips from each of the injectors. Sure enough, the #4 cyclider had a loose wire just like the one in your picture. The cylinder was never getting any gas. I removed the rubber insulator and jammed the wire into the female connector. Then i jammed the entire connecter onto the male part, making sure to shove the wires into place. Never had a problem since. Its funny to see how the car can run, even with only 3 cylinders working. Damn thing never even stalled when it was like that too!

--
-Brandon at FSU '88 744ti 156k miles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New It wouldn't start! [700]
posted by  john sargent subscriber  on Mon Mar 3 19:08 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.