Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Overdrive wiring problem (button to relay) 200 1982

posted by  ODGuru on  Sat Apr 19 02:19 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 4 18:52 CST 2014
[RELATED]

At the relay socket, there shold be two boue wires into 15.

One is to the fuse panel, the other is down and under the passenger side center consloe cover, then under the carpet, a two wire connector,(blue and brounn) then the leads into the shift tube. Find the connector, then test both directions.

Most likely it will be a broken wire at the point the wires enter the shift tube. I'd replace/repair the brown wire also since it follows the same route and is subject to the same stresses.

Duane






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Overdrive wiring problem (button to relay) [200][1982]
posted by  tjl  on Fri Apr 18 11:14 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.