Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2008 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Using a B230F block in a Turbo? 700 1989

posted by  jpgurley on  Sun Jun 15 16:07 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Dec 10 03:50 CST 2010
[RELATED]

Thanks Dick,
I was considering putting a tee off of the oil sender unit for the supply line since mechining the block to seal a banjo nut fitting looked a bit risky. I think it all feeds off the same oil passage so do you see any problems with that?
Thanks, Jon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Using a B230F block in a Turbo? [700][1989]
posted by  jpgurley  on Sun Jun 15 15:30 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.