Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Start up problems 200 1988

posted by  someone claiming to be Niel on  Sat Jul 12 09:36 CST 2003 [RELATED]

It almost always runs fine, so I would go for the fuel pump relay or fuse contact as someone described. On my 760 all the relays had broken solder, and my '88 240 had only one relay without broken solder. Distance traveled has very little effect, it is due to the age of the solder. And now we are switching to lead free solder, so who knows what problems will occur in 10 years time.

If you have K-Jetronics, look at the relays and then replace the ignition module, if it was not the relays. (My 1988 is still K-Jet.)

With newer electronic FI, it might also be the FI computer, but it's expensive to replace. First check the connector.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Start up problems [200][1988]
posted by  someone claiming to be crazyvine  on Fri Jul 11 14:39 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.