Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

testing ignition amp output/coil input 200 1992

posted by  Cliff Pope on  Thu Aug 28 23:02 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Feb 3 05:28 CST 2011
[RELATED]

I've just had the power amplifier on my 93 diagnosed as faulty. Apparently they are known to be sensitive, and can partly fail when cold, damp etc. All I did was remove it, separate from its heat sink, clean off all the corrosion and refit. It works perfectly now. I was advised always to carry a working spare.
Crank sensors too break down with age. Measure the resistance between the centre pin and one of the others - only one will give a reading. I can't remember what the limits are, but my 167 Ohms is apparently fine.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New testing ignition amp output/coil input [200][1992]
posted by  cn52x5hg subscriber  on Thu Aug 28 13:21 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.