Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Timing Cover etc,,, 140-160

"...the cylinder walls are sleeved. Is this normal, or did a previous owner have some crazy work done..."

Don't know, good question.

"What is the stock spec on cylinder diameter?"

Also don't know and also a good question. It should be in any of the service manuals. (Haynes says 3.5"=88.9mm bore for the B20A engine and 3.5008"=88.92mm for the B20E engine.)

I bored out several B20s (both 6- and 8-bolt styles) to B21 diameters, and one was taken to B21 +0.060".

All ran fine. Superduper fine, in fact.
--
Don Foster (near Cape Cod, MA)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Timing Cover etc,,, [140-160]
posted by  someone claiming to be kingcong  on Mon Sep 15 00:50 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.