Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Thin wire to starter........ 200

posted by  B.C. on  Sat Sep 20 20:13 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 28 22:28 CST 2012
[RELATED]

The earlier models used a resistor in the coil primary to reduce the voltage.
The starting system had circuitry to bypass the resistor, and this is the brown wire.

Later models don't use a resistor, so no brown wire. The BL-Y wire is from the ignition switch, and still goes on the terminal towards the LF fender.

Good Luck,

Bob

:>)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Wiring Harness Job - Going Badly - Please suggest a solution cause I need help! [200]
posted by  JoeTown244GL  on Sat Sep 20 13:42 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.