Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Walker 200 1990

uid 27's pic
posted by  Art Benstein on  Wed Oct 22 09:07 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

Good question. I needed a single wire sensor for an older car and fulfilled that need at FCP Groton. I think that was only 13 bucks. The one that was drowned in ATF I replaced with a four-wire sensor that was part of a lot I happened to find on ebay auctioned as something else. The fourth wire is a ground-- supposed to be a better reference than the one you get through all those rusty exhaust pipes.

If I needed to buy a heated sensor, I'd get the Walker from FCP, mostly because Nick seems to always come through for me. And I don't mind the crimping and sleeving part. But if Bosch always comes through for you, I believe you could try a local auto parts store. I think there's a very common heated sensor assembly used by a Mustang that sells in that range. Of course you still need to crimp and insulate.
--
Art Benstein near Baltimore






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New reasons for oxygen sensor failure? [200][1990]
posted by  someone claiming to be zakir  on Mon Oct 20 07:52 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.