Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2020 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

One cylinder injector problem 200 1986

1986 244 GL 192K

I believe I have isolated an intermittant problem I am having to #3 injector. In an attempt to isolate where the problem is I want to install jumper wires from #2 injector to #3 injector to see if the problem lies in the electrical impulse or the injector itself. Is this a reasonable method (jumpering)? I am under the impression that all of the injectors fire at the same time in the LH system so where you get the impulse doesn't matter; safe assumption? The boots on the injector plugs are in bad shape and the connections at the injectors were slightly corroded (but clean now). I'm thinking it might have wiring harness issues.

I would like to connect an LED to the injector plug but have found that one that is connected will flash a couple of times and die. Obviously I know nothing about LED's, but I am assuming even though the LED is rated for 12v the amperage is too great and blowing the LED. I posted yesterday about connecting an LED without any luck.

Jumpering 2 injector to 3 injector OK? As always, thanks.

Randy






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New One cylinder injector problem [200][1986]
posted by  rstarkie subscriber  on Sun Dec 28 05:57 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.