Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Removing surface rust 200 1983

posted by  Mac_Muz on  Mon Dec 29 21:11 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 30 19:26 CST 2011
[RELATED]

Light surface rust with no pitting? If so 180 grit on a block by hand is good, then 220 to prime. I like NAPA econo brand papers for this sort of work, as it has a sticky backing, made for a DA, but it hand sands well too... With used pieces you can fold and get to any place.

If there is pitting then something else again...

In any case consider a chip guard over the primer, which can be left black or painted the same color.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removing surface rust [200][1983]
posted by  VolvoKurt  on Mon Dec 29 17:13 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.