Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2010

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

I am going to get this 240 tuned! amm and adjustment screw

posted by  porkface on  Fri Feb 6 10:58 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:12 CST 2014
[RELATED]

ok, got my notes. disconnect the harness and hook the ohm meter to pins 12 and 36. twist the co screw until you find 380 ohms-dead on. now, plug it in and try again. pin 7, key on, engine off voltage is 1.6, at idle-2.8, at 3500 rpm-3.5. this assumes idle is set correctly to spec. and 12v or better at pin 9. can't get 380 ohms-replace the amm. good luck, chuck.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I am going to get this 240 tuned! amm and adjustment screw
posted by  landlockedsurfer subscriber  on Thu Feb 5 14:47 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.