Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

no clearance at tranny cross member- Any ideas 200 1990

posted by  lrisius on  Sun Feb 29 13:39 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 17 05:59 CST 2014
[RELATED]

Hi,
I put new motor and tranny mounts on my "new" 1990 240 a couple of weeks back and since have been fighting exhaust noise problems. The header pipe is either touching or almost touching the transmission cross member. My other 240 has between .5 and 1 inches of clearance there. It didn't do it before the new mounts- my theory is that the old ones had enough sag to let them work. I've adjusted the header pipe bracket down as much as I can- there is still a little adjustment space but I just can't get it there. Best I can tell the muffler system is straight. I found some old posts about getting the uniframe bent by using the mount bolts as a jacking point, but they don't seem to be pushed in and I don't think I have driveline problems.

Any ideas? I used the mounts from FCP Groton. Could the tranny mount be too thick or something. Would it be okay for me to pull the 1/4" spacers? I think that would help some.

Thanks for the help. This is getting OLD.
Lyle






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New no clearance at tranny cross member- Any ideas [200][1990]
posted by  lrisius  on Sun Feb 29 13:39 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.