Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ignition Control Unit 200

I had so many problems with the ICU connections that I wouldn't even try to tell you everything I tried to get it to stay.

Yes, a new harness is one way to go if you have the time and the money.

But after trying the sleeves (what a joke) and electrical grease (made it worse) I finally just went to the junkyard and cut off the female end and spliced it onto the correct wires. $5 and about an hour install. Make sure you have the same year. Have your old one with you for comparison.

Warning. There is one wire that has an inside and an outside wire together. DO NOT let these contact each other. That one is a tough one, but can be done with some care.

Good luck.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition Control Unit [200]
posted by  ddpphx  on Fri Apr 30 21:38 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.