Do this with the battery disconnected.

Remove the knee pad, and the fuse-surround kick panel.

Get the rubber piece between the door and frame out of the hole in both door and frame. It will just hang on the wires already in there.

Then you can use a relatively stiff wire to get into the frame hole and up to where you can see the end of it. Make a little loop in the wire first, it will keep the sharp end from poking things, and will be helpful in pulling back through a very strong string.

Use the string to pull through the power window wires. Then you can insert them through the rubber thing and then inside the door. Re-attach the rubber thing.

No, I haven't done that, but if I were to, that's what I would do.

Good Luck,

Bob

:>)