Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2002 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

J type OD into a 122. 120-130

posted by  hans on  Sat Jun 19 10:45 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 19 15:26 CST 2014
[RELATED]

The M41 flange is finer than the M40, what you need is a flange from a pre fuel injection 140, in the photo the flange on the left is from a 84 240 with M46, the one on the right is from 69 142 ( this one fits your drive shaft and your gearbox ) with J type M41, both these fit on a M41, the one in the middle is from a 75 M40 and won't fit an M41, earlier M40's have a flange the same size as teh one on the right but with the same spline as the one in the middle.
As you will probably have to cut your driveshaft anyway the easist thing to do is find the front part of a fuel injection 140 or even easier a 240 driveshaft.
Ciao
Hans







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New J type OD into a 122. [120-130]
posted by  pearl  on Fri Jun 18 09:56 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.