Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2003 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

B18 head on B20 block 120-130

posted by  someone claiming to be mjamgb on  Fri Aug 13 11:56 CST 2004 [RELATED]

The slanting would be fine on all sides but the quench areas (you want tumble there). Insofar as the shape is concerned, a "figure-8" is considered the best chamber shape for two-valve heads with a spark plug in the middle. Of course, realities of construction make that nearly impossible. If there is enough meat in the head without going into the water jacket you will be OK... There may not be that kinda metal to work with.

More likely, you will end up making is less angled and more "dished" in an attempt to get more volume so your static CR isn't astronomical.

Mike!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B18 head on B20 block [120-130]
posted by  Bennie  on Fri Aug 13 06:23 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.