Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2001 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Sun Visor Placement 120-130

posted by  Phil S. on  Thu Oct 21 13:09 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 13:18 CST 2014
[RELATED]

Ha! Been there, done that...

The triangular mounts on the visors face upwards, with two screw holes in the bottom edge and one on the top.

The bottom edges of the triangles are about 1/4" above the inner windshield trim.

The outer bottom corners of the triangles are about 2" inboard of the windlace.

Take a needle and poke through the perforations in the headliner to really locate the holes for sure. Once you find the large hole the spring on the visor goes through, make a razor cut in the headliner there. Then you can hold the visor up in place while you find the three screw holes.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Sun Visor Placement [120-130]
posted by  Tom O.  on Thu Oct 21 12:32 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.