Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

brake line junction problem, please help 200

uid 27's pic
posted by  Art Benstein on  Sat Nov 6 04:58 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

I won't address the philosophy of new vs. used, but instead, just point out the seal on the switch is not designed to keep hydraulic pressure inside, but to keep dust outside. The leak, if it appears there, is not due to the switch seal, but to the seal made at the internal O-rings as Lucid points out. Yes, this is the job that justifies getting the best 11mm line wrench you can afford.
--
Art Benstein near Baltimore






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New brake line junction problem, please help [200]
posted by  nebulous1  on Fri Nov 5 12:37 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.