Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2006 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to Test Throttle Position Sensor? 900 1994

posted by  someone claiming to be bob on  Sun Nov 14 16:21 CST 2004 [RELATED]

To test throttle position sensor on LH-2.4. Go to the diagnostic socket at the strut tower, and access A-2 as if reading fault codes. Turn on ignition switch, rotate throttle spindle midway between idle and WOT and hold it there. Press the button on diagnostic socket 2 times while holding throttle. When the LED starts to flash, turn throttle to WOT. The led should stop flashing briefly and flash out a response code of 3-3-3, throttle switch ok at WOT. If this code comes up, wot portion of signal is ok. When the light flashes rapidly again, release throttle to idle. LED should flash a 3-3-2 code, throttle switch ok at idle.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to Test Throttle Position Sensor? [900][1994]
posted by  Volvodad subscriber  on Sun Nov 14 06:02 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.