Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ABS LIGHT ON 700

posted by  Aye Roll on  Tue Jan 11 15:52 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 14 21:08 CST 2014
[RELATED]

You can pull the sensors out of the backing plate- one screw I think, it's been a while since I looked at them.

They're magnetic and pick up brake rotor filings and road grit. I clean them off with masking tape- it pulls up any filings quite well. The sensor has kind of an edge that looks at a wavy ring. Other than clocking the rotor to the locating bolt holes, there's no special alignment or anything if you take it off. If you do take the rotor off, clean the ring with a wire brush or something, it can't hurt.

Good luck!
--
Rob Bareiss, New London CT ::: Roterande Fläkt Och Drivremmar!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ABS LIGHT ON [700]
posted by  someone claiming to be Frank  on Tue Jan 11 10:36 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.