Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2001

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

spray foam insulation as a structural component?

posted by  NJC on  Mon Jan 24 10:01 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jul 24 13:42 CST 2011
[RELATED]

I've used it to plug up a hole from wheel well to trunk. I then covered the foam with spray on asphalt (tar). I didn't sand it, of course, since I couldn't get at it.

I've also used alum with pop rivets and then tar; conversely you could use coated sheet metal too.
--
Norm Cook Vancouver BC; 1989 745T 202,000KM






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New spray foam insulation as a structural component?
posted by  kevhito  on Mon Jan 24 07:15 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.