Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

temperature problem 200

posted by  volbro245 on  Thu Jan 27 13:36 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Nov 6 18:05 CST 2013
[RELATED]

I have just jumpered the two wire. It is a bit tight,so what I did was soldered and crimped on some very small splice tubes to the wire, filled the tubes with solder and then heated them and slid them over the pins. Its a bit hard to explain. Im sure there are many ways to to it. Worked great. Temp reads fine. But if like others suggest its the sender then this will be of little value, other than you know its not the comp board.

I thought of something else to check, how is the belt tension on the water pump?
Any chance it could be slipping?

Good luck

Mike in Tacoma
--
Mike in Tacoma






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New temperature problem [200]
posted by  3 Volvos  on Tue Jan 25 15:32 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.