Volvo RWD S90-V90 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2007 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

sealing foam S90-V90 1996

When you take the light assembly off you'll probably find (if it's anything like my 240) a foam/rubber gasket that compresses to make a tight seal between the light assembly and the metal. Over time, and especially through warm / cold cycles, the foam can shrink a bit and start to leak. Just taking off the light and reinstalling it was enough to make the foam do it's work again for me... while you have the light off, make sure there are no cracks in the plastic that would allow the water to seep through. Good luck!!!

-Flup






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New water leak rear lights? [S90-V90][1996]
posted by  analyzer subscriber  on Wed Feb 2 11:04 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.