Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Two things...er...Three things 700 1990

posted by  Greydog on  Sat Feb 5 11:55 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi Guys,

Thanks for your replies.

It seems as the problem is becomming progressively worse. I noticed today that where before the light would go out at about 1,200 rpm, now it has to reach about 1,800 rpm before it goes out.

Today I replaced the oil pressure sensor and the low oil pressure light problem still exists.

Being as I don't hear any rod knock (just the usual piston slap), I can't bring myself to believe excess bearing clearance is causing the problem.

I have resigned myself to the fact that it is either the pump or feed tube o-rings. Unless anyone has any better ideas, I'll replace the pump and o-rings. I'm certianly not going to all of the trouble of dropping the pan only to swap out a couple of o-rings and hope that that was the problem.

I have a reasonably equipped garage, but I don't know if I want to tackle this one or farm it out. Any suggestions?

Thanks again,

Greydog
--
Greydog....'90 Turbo Wagon.....really sweeeeeeeet!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Two things...er...Three things [700][1990]
posted by  Greydog  on Fri Feb 4 13:47 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.