Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Getting Ready to replace sunroof seals. 200 1990

posted by  jwalker on  Thu Feb 10 06:29 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jun 6 08:39 CST 2014
[RELATED]


Good you cleaned out the drains. IMO - Also check sunroof adjustments first before going after the seals. Those seals ain't cheap!

If you go ahead with the seals, get some 3M Plastic & Trim Adhesive to use. Great stuff! Are you doing both? The front is easy, the rear a little tougher to get at. After removing old seal, scrape and clean area carefully before applying sealant. You want a clean surface. Not too bad a job, but take your time and be patient putting in the new seal.





--
90 244DL 1/4 million miles - original engine/drivetrain :)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Getting Ready to replace sunroof seals. [200][1990]
posted by  acmanell  on Thu Feb 10 05:12 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.