Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

electrical difficulties 200 1986

posted by  cbremski on  Mon Feb 14 16:59 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

look for corroded or burnt connections at the bulb connection (this being your park and taillight). High resistence is caused by corrosion and heat. Make sure you have the correct bulbs in all those lights (skip the instrument cluster unless you know you have changed those, it would be a wasted effort). The wrong bulb would draw too much amperage and overload the circuit.

I would suspect you don't have any bad grounds or else the circuit would just not light up at all and blow the fuse. however if this is the case, check your grounds for that circuit and make sure they are not loose.

Check the wiring for each light and see if anything is ripped open and grounding that way.

Best of luck!
Chuck in mpls
(ASE certified in automotive electrical among other stuff)
--
'87 BMW 325e 190K (used to feed a '84 245, '88 244, '84 244, '85 744)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New electrical difficulties [200][1986]
posted by  volvolover102  on Mon Feb 14 15:36 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.