Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Poly Bushing Installation 200 1993

posted by  mbliss on  Sat Mar 26 07:01 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 21 20:49 CST 2014
[RELATED]

What do you mean by "control arm?" I don't see that as a component of the rear suspension -- do you mean the track rod (aka panhard rod)? The reason I ask is that my '81 has developed a nasty vibration. All three U-joints were replaced last fall. I should have had the center bearing done at the same time, but didn't. On the other hand, it feels fairly solid. I replaced all four bushings in the torque rods, which changed/reduced the vibration, but didn't eliminate it. Vibration seems worst at about 35-40 and around 55 mph, but sometimes goes away or at least isn't so bad.

--
'81 GLT 245 @ 259K; '83 DL 175K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Poly Bushing Installation [200][1993]
posted by  Irollturbo  on Fri Mar 25 18:47 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.