Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2005 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine Builders: Bottoming Taps? 120-130

posted by  someone claiming to be Rhys on  Sat May 28 18:35 CST 2005 [RELATED]

Cylinder head bolts are 7/16 UNC, and I use a plug tap, which does not cut new threads at the bottom of the hole. The bottoming type will, and it is not required to go quite that far.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine Builders: Bottoming Taps? [120-130]
posted by  mario_e  on Sat May 28 15:42 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.