Volvo V8 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

New engine woth longtube headers

uid 6548's pic
posted by  Volvord 784VC on  Mon Jul 18 03:49 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jun 20 02:46 CST 2007
[RELATED]

It has been a long rebuild but it is almost finished and I thought you all might like to see the progress.

The engine is a Ford 5.0L with Custom blueprinted Ford 5.0L, Forged 10.5:1, DSS main stud girdle, DSS windage tray, ARP stainless steel bolt/stud throughout, CompCams XE274HR cam (274/282 duration @ 0.600" / 0.607" lift), Stage 3 ported Edelbrock Performer RPM heads, Manley comp valves, DSS 1.72 roller rockers, Edelbrock Performer RPM Intake, Edelbrock 1405 Carb, Custom 1 5/8” long-tube headers, MSD6AL Ignition, Ford Racing T5Z close ratio transmission, B&M short throw Ripper Shifter, TrueTrac LSD w/ 3.73 gears, Spec Stage 2 clutch, iPd lowering springs, 1” sway bars, Urethane bushings.

Headers are Mac longtubes, the right side fit with only minor modification but the left side were completely custom..


--
Volvord 784VC www.telusplanet.net/public/gilesij/Volvord







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New New engine woth longtube headers
posted by  Volvord 784VC  on Mon Jul 18 03:49 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.