The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Need some driveshaft advice

posted by  someone claiming to be 18 on  Wed Apr 13 09:24 CST 2005 [RELATED]


Hi
I used a one piece driveshaft from an oldsmobile. Fit the back of the T56 just fine. It starts out at 2 1/2 inches and goes to 3 inches after about 8 inches or so. I cut the back end off so it stays 3 inches all the way to the back. Per JTR I used the larger companion flange and bigger than stock U joint. At first it touched at the two bolts sticking threw the floor that secures the seat belt anchors. I took a porta-power and just spread this 1/2 an inch or so. Never touched since. By the way I used the IPD adj. torque arms and followed the included instuctions to adjust the pinion angle. Again, works like a champ.
18






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.