|
It's been a while since I posted/updated.
Had the injectors cleaned, all performed fine (according to shop). Got new o-rings and spacers. installed them all.
Car ran better, BUT still a little rough/hesitation. So I tested the vacuum areas with spray water, and at the injector ports. No change.
Disconnected the #1 injector wire, and there was no change. #'s 2-5 all had a noticeable change. Like, the car wants to stall and then corrects itself.
Does that seem to point to a bad connector or something computer related? I'm going to look around on the board for some suggestions (including some I've already received).
Thanks again
btw, I know it's not an injector itself, because I did not install them into the same port as before (I did not # them before I had them cleaned).
--
1985 245. 246K Gone..but not forgotten.
|