The message to which you are about to reply is shown first. GO TO REPLY FORM
posted by
someone claiming to be yuri
on
Thu Mar 28 18:00 CST 2002 [ RELATED]
|
|
1st you don't need to drill anything - the oe lights should go where you have black "inserts" on ea side of the bumper.
2nd i installed them in the middle on the sides of the license plate and used screws that hold plastic bumper cover to mount the brackets that hold the lights so no drilling was needed.
3rd my 95 850glt did have the a single orange/green wire connector by the battery and it was hanging (there is another connector by the buttery that inserts into a dummy plug - i don't know what it for but it did not have proper voltage/ power)
4th my car needed relay switch and relay/switch harness that i had to modify since it had two relay holders and also installed a fuse there - the existing wiring on mine goes from under dash to the battery and that is it
WHEN YOU WORK UNDER DASH DO NOT PULL/TOCH ANY OTHER WIRES - I HAD LOSE TERMINAL THAT DEALER SAID i MIGHT HAVE DONE WHEN INSTALLING FOG LIGHTS
|
|
* = Field is optional.
+ = Enter space delimited labels for this post. An example entry: 240 muffler
©Jarrod Stenberg 1997-2022. All material except where indicated.
Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.