Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2005 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Has anybody ever succeeded using Scantool..? 850 1986

posted by  Yellow 850 on  Tue Feb 14 18:15 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Steve,

Yes I'm using a purchased Elm323 v2, I live ocean away from you where OBD2 is not mandatory, my other car (grand vitara) don't have OBD2 interface.
Digimoto lite provides a tab/page similar to hyperterminal where you can throw AT codes and receiving ECU response in hexadecimal. I only recoqnize AT commands listed on ELM323 datasheet like ATSI, ATZ, ATBD, but when I throw 03 requesting fault codes, it response is always 'NO DATA'.

Yes, baut rate problem is possible, but there is nothing else we can do right?the baud rate is always set in 9600 (maximum) and it is greyed (non updatable). When I do ATSI (slow init) I will get BUS INIT: Ok, unlike when I ATFI (fast init). So I will try lower the baud rate and see what happen..

I doubt that other software do better because they basically throw the same AT codes (I guess) and what they do are just translating those hex to english, but i'll give it a try sometimes.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Has anybody ever succeeded using Scantool..? [850][1986]
posted by  someone claiming to be Yellow 850  on Mon Feb 6 23:06 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.