Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2006 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fault Code & Ohms: Diagnose my Throttle Position Sensor / Switch 850 1995

posted by  Rockytop on  Mon Feb 23 02:17 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 10 13:59 CST 2011
[RELATED]

Thanks again for the reference values. Here are the resistance values from my Throttle Position Sensor (Part # 0280122001 or 1336385):
1278 ohms
4000 ohms
What do you think? Are those far enough off to indicate problem?

> When performing OBD, Diagnostic Test Mode No. 2 (Function Testing), I get no Acknowledgment Code (should be 3-3-2) when throttle leaves idling position.
> When throttle leaves full-load position, I get not the expected 3-3-3, but rather the 3-3-2 that should indicate idle position.

> I get fault code 1-1-3 "HO2S Integrator Max Enrichment Limit" (Short term fuel trim lean) after idling 3-4 minutes; no fault code if I just drive.

>>Throttle position switch toast? Any other cause for those symptoms?
--
Two 1995 854 GLT's (w/ manual transmissions)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New anyone know how2 &quot;Bench Test' Throttle Position Sensor? [850][1995]
posted by  Rockytop  on Mon Feb 16 03:58 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.