Volvo AWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Service light

posted by  someone claiming to be Jone on  Thu Dec 20 08:03 CST 2001 [RELATED]

1. Turn the ignition to the KPII position so the warning lamps on the dash are illuminated.

2. Locate test port(A) in the engine compartment behind the passenger side headlamp.

3. Remove the cover and pull the test lead wire out of the holder in the cover.

4. Insert the jumper into terminal #7, then press the buttom 4 times, wait approximately 5 seconds, and the red lamp should glow continuously. You are now in the data reset mode.

5. Press the button 1 time, and wait 5 seconds for the lamp to glow again, then press the button 5 times. After 5 seconds, the lamp will illuminate again; press the button 1 time, and you will see the lamp flash repeatedly for a couple of seconds indicating that the service lamp has been reset.

6. If a mistake is made, simply switch the ignition off and back on, to reset and start over.

NOTE: This reset procedure is applicable for 1993-1995 850 models only!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Service light
posted by  someone claiming to be Liz  on Fri Dec 14 12:07 CST 2001 >
  • New Re: Service light
    posted by  someone claiming to be Jone  on Thu Dec 20 08:03 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.