|
Reset service light on a 1995:
Insert diagnostic probe into slot A-7. Push black 4 times, wait for red light. Push angain 1 time, wait a second, push 5 times, wait a second, push again 1 time. done.
To use the OBDII, the key must be in position II and the doors closed.
Now, the 323 code is for the left rear wheel sensor with problems at over 25mph. This is usually because of a dirty axle, not a wiring problem. I am surprised you replaced your ABS module since 1994-5 are quite robust, unlike the 1996+ cars.
If the PNP switch has been replaced, tell the mechanic to put the car in R with the ignition on and check the back up lights. If the lights are not on, the PNP needs to be aligned properly. What are the current tranny codes?
Klaus
--
Proud owner of a 220S. If I had more room, I would have more Volvos.
|