Volvo AWD S70 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 S70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Lambda light, after installing side markers? S70 1998

posted by  Ananda on  Fri Feb 8 05:18 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

First off, thanks for your time and your sharing of your knowledge!!

For some reason at the time, I had thought that the white/blue, blue/red wires may somehow need to go into the engine bay. So i did not cut them, i just peeled the cover off. Then i tapped them into the green and black wires that go to the front turn signal. At that point, the front turn signal was giving power to the side marker AND to whatever was on the other end of the wires, I guess the valve. But the end that I hooked up to the side markers wasn't hooked up to anything, it was attached to the inside of the wheel well. Does the diagram show where the blue/white, blue/red harness should be connected to. Was it not purging since it wasn't connected? AND do i need to see the dealer, to either fix the valve, and/or turn the Lambda off?!

Thanks again!!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Lambda light, after installing side markers? [S70][1998]
posted by  Ananda  on Wed Feb 6 04:12 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.