Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2000 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Sway Bar Links - How to replace? 850 1995

posted by  someone claiming to be Kirk on  Tue Apr 2 08:03 CST 2002 [RELATED]

The links in the '95 do not have a torx end. I replaced mine a few months ago.

What you need to do is insert a wrench between the strut and the sway bar link connection. There are two flats on the inside of the bolt that is turning. I think it is a 15MM. Unless you have a cone (thin) wrench this may tear the rubber boot around the joint, if you are replacing them it doesn't matter.

I pushed the wrench in the tight space and turned the nut until the flat spots were just right and the wrench slid in place holding the link.

Same is true for the bottom. The replacement links have a torx opening on the end and are easy to replace using a wrench and 27Pt. torx bit.

Good luck.

Kirk






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Sway Bar Links - How to replace? [850][1995]
posted by  someone claiming to be Yuri  on Mon Apr 1 12:37 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.