Volvo AWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2010

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Installing a HKS variable boost controller

posted by  wlewish on  Tue May 14 15:07 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am still new to all of this and need a lot of help. I own a 1994 940 Turbo with the following modifications: modified airbox with K&N panel filter, MVP 3" complete exhaust system, one turn on the wastegate rod. Last fall I bought a HKS variable boost controller (part # 17265-111US) from a local speed shop, but never got around to installing it - didn't want to start cutting hoses until I fully understood what I was doing. I've checked the forums on this site and Turbobricks and I still can't figure out how to do this installation. Putting a tee into the actuator pressure line between the turbo and the wastegate actuator, then connecting a hose to the Flow In side of the valve makes sense, but I have no clue how/where to connect the Flow Out side of the valve to a compressor suction source as instructed. Can anyone point me in the right direction?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Manual Boost Controller (long) [850]
posted by  Quaz  on Fri May 3 15:26 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.