Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Roof Molding-installation 850

posted by  markas on  Mon May 5 04:11 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jan 2 04:39 CST 2010
[RELATED]

Hi ya 850yuppy.

its a fairly easy procedure as i take mine off once a yea to clean the recess as i show my car :-)

If you start at the base of the windscreen lift up gengle and continue up the whole to the rear.

You will see many clips some of them different colours, if any came off while you remove them they need to go back in their original positions. They easily clip is place nd make sure the clip holding the trim is not to wide.

You should have in your kit some duobble sides stickies fr the end rubbers needed at the end.

I aline every thing up and start from the A piller downward to the windscreen base and then to the rear or the car. Then use your sticky bit for the rubber end.

mark.
uk voc 94 850glt 2l 20v 194k.
--
Mark in the UK.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Roof Molding-installation [850]
posted by  850yuppy  on Sun May 4 01:23 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.