Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2018 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Roof Molding - Installation 850

posted by  mark b. on  Sun May 4 06:19 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Mar 6 03:57 CST 2001
[RELATED]

The clips for the molding should be in place when you remove the original molding. It's an easy job. When I replaced mine, I started at the windshield end, and just gave the original molding a good upward tug. It pops out one clip at a time, down the length. Then you just reverse the procedure to install the new piece.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Roof Molding-installation [850]
posted by  850yuppy  on Sun May 4 01:23 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.