Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2012 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

WHEEL BEARING HUB REPLACEMENT EXPERIENCE 850 1994

posted by  kshaw on  Sat Aug 28 15:01 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 29 13:11 CST 2008
[RELATED]

I followed the Bay 13 guide and had no problem. You can squirt PBlaster on the the shaft and that should help it slide out easier. I removed the axle nut with an impact wrench and then screwed it back on partially as suggested on the Bay 13 guide. I rapped it a couple of times with a small hammer and it losened pretty easily. On the noise, there is a metal plate behind the rotor that can rub the rotor. Just use a large screw driver to move it back a fraction of an inch so that it doesn't touch the rotor.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New WHEEL BEARING HUB REPLACEMENT EXPERIENCE [850][1994]
posted by  Xraybob  on Sat Aug 28 13:10 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.