Volvo AWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Return the bushing to dealer and tell them you are not

posted by  the kick inside on  Thu Oct 14 09:00 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 17 09:58 CST 2007
[RELATED]

ok..heres the low down..i put a volvo one in using some 10mm bolt, two nuts, some washers and somw wodden disks cut out of 3/4" pine...

i DID reduce the diameter marginally using some oxide sand paper (and increase the taper on the end) and i DID grease it before insertion....

IF i had to do it again i would go genuine again, but would use my lathe (didnt have it then) to skim a couple of thou off the diameter...

honesty it IS possible, took me maybe an hour of swearing before i took the time to make the disks up to fit..then took 10 mins...no special tools, not built like a gorila...






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AM I RETARDED ??????????????
posted by  someone claiming to be volcan  on Wed Oct 13 12:53 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.