What I did was to disconnect the rubber hose from the metal s shaped pipe that runs from the turbo and over the top of the engine. This rubber hose goes to the bottom of the intercooler. I then disconnected and removed the plastic hose that comes from the top of the intercooler and goes to the TB rubber hose. I had to cut the metal s shaped pipe that comes from the turbo ( aluminium). I tried to find the best section to cut it so that I would be able to rejoin it in the spring with a small section of rubber hose. From the cut section of metal pipe I ran a spring reinforced ( radiator hose) down to a nylon right angle plumbing fitting and into the TB hose. I will have to look to see what all of the hose and fitting diameters are. If you put your e mail on this brickboard I can send you a picture of the finished job.