Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2010 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

There are some parts which seem unobtainable are there any suggestions for this one? 1800

posted by  jgcoutts on  Sun Dec 26 11:23 CST 2021
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Ron, yes it’s just a press fit, I was surprised how easily the original came out with a haemostat clamped to the lip. Now the challenge is turning down the copper washers outer diameter, I’m thinking of a long machine screw and a nut to clamp it from spinning and provide a mandrel to put in a chuck to turn it while using a file. After soldering the new mesh basket in place then either using a 1/4” drive socket on an extension or a length of pipe to hold the part and press it in place.

Does anyone know what the reproduction version of this same master cylinder uses for a filter or if they have one?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New There are some parts which seem unobtainable are there any suggestions for this one? [1800]
posted by  jgcoutts  on Thu Dec 23 22:42 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.